Call Us
Customer Support & Sales
+919996186555
Home » Products » Fluid Mechanics and Hydrology Equipment » Centrifugal Fan Teaching Trainer

Centrifugal Fan Teaching Trainer

Centrifugal Fan Teaching Trainer
Centrifugal Fan Teaching Trainer
Send Inquiry
Product Code : FMH-102
Product Description

Centrifugal Fan Teaching Trainer

Advanced Technocracy Inc. is Manufacturer, Exporter & Supplier of  Centrifugal Fan Teaching Trainer


EXERCISES AND PRACTICAL POSSIBILITIES
Some Practical Possibilities of the Unit:
1.-Measurement of constant-speed machinc performance in terms of static and total pressures, rotor speed and motor shaft power, as a function of inlet flow.
2.-Calculation of flow with and orifice plate.
3.-Calculation of the fan efficiency.
4.-Introduction to similarity laws for scale-up.
5.-Calculation of the flow by static pressure measurement, dynamic pressure measurement and total pressure depending of the test.
6.-Practices with the different turbines: with the blades forwards, with the blades backwards and with flat blades.
7.-Determination of the fan characteristics curves.
8.-Calculation of the typical curve of a fan at a constant turning speed (turbine with blades forwards).
9.-Calculation of the typical curve of a fan at a constant turning speed (turbine with blades backwards).
10.-Calculation of the typical curve of a fan at a constant turning speed (turbine with flat blades).
11.-Measurement of performance at constant speeds.
12.-Static pressure increasing.
Other possible practices (with the optional Set of Accessories):
13.-Calculation of flow. Test with discharge duct and nozzle.
14.-Calculation of flow. Test with aspiration duct and nozzle.
15.-Calculation of the differential flow according to the turbines position in the discharge duct.
16.-Calculation of the differential flow according to the turbines position in the aspiration duct.
17.-Determination of the fan characteristics curves (with the optional Set of Accessories).
18.-Measuring a cooling curve.
19.-Determination of the coefficient of heat transfer from the cooling curve.
20.-Measurement of the pressure distribution around a cylinder in a transverse flow.
21.-Measurements behind a cylinder in a transverse flow.
22.-Pressure loss measurements at a bend.
23.-Pressure loss measurements on pipe sections.
24.-Pressure loss measurements at an elbow.
25.-To investigate the influence of different shaped pipe inlets.

ADVANCED TECHNOCRACY INC.
X